The kilowatt hour (symbol kWh, kW?h, or kW h) is a derived unit of energy equal to 3.6 megajoules. If the energy is being transmitted or used at a constant rate (power) over a period of time, the total energy in kilowatt-hours is the product of the power in kilowatts and the time in hours. The kilowatt-hour is commonly used as a billing unit for energy delivered to consumers by electric utilities.
The symbol "kWh" is commonly used in commercial, educational, scientific and media publications, and is the usual practice in electrical power engineering.
Other abbreviations and symbols may be encountered:
"kW h" is less commonly used. It is consistent with SI standards (but note that the kilowatt-hour is a non-SI unit). The international standard for SI states that in forming a compound unit symbol, "Multiplication must be indicated by a space or a half-high (centered) dot (?), since otherwise some prefixes could be misinterpreted as a unit symbol" (i.e., kW h or kW?h). This is supported by a voluntary standard6 issued jointly by an international (IEEE) and national (ASTM) organization. However, at least one major usage guide and the IEEE/ASTM standard allow "kWh" (but do not mention other multiples of the watt hour). One guide published by NIST specifically recommends avoiding "kWh" "to avoid possible confusion".
The US official fuel-economy window sticker for electric vehicles uses the abbreviation "kW-hrs".
Variations in capitalization are sometimes seen: KWh, KWH, kwh etc.
"kW?h" is, like "kW h", preferred with SI standards, but it is very rarely used in practice.
The notation "kW/h", as a symbol for kilowatt-hour, is not correct.
Wires - about colors
To enable wires to be easily and safely identified, all common wiring safety codes mandate a colour scheme for the insulation on power conductors. In a typical electrical code, some colour-coding is mandatory, while some may be optional. Many local rules and exceptions exist per country, state or region.1 Older installations vary in colour codes, and colours may fade with insulation exposure to heat, light and ageing.
As of March 2011, the European Committee for Electrotechnical Standardization (CENELEC) requires the use of green/yellow colour cables as protective conductors, blue as neutral conductors and brown as single-phase conductors.2 The United States National Electrical Code requires a green or green/yellow protective conductor, a white or grey neutral, and a black single phase.3
The United Kingdom requires the use of wire covered with green insulation, to be marked with a prominent yellow stripe, for safe earthing (grounding) connections.4 This growing international standard was adopted for its distinctive appearance, to reduce the likelihood of dangerous confusion of safety earthing (grounding) wires with other electrical functions, especially by persons affected by red-green colour blindness.
In the UK, phases could be identified as being live by using coloured indicator lights: red, yellow and blue. The new cable colours of brown, black and grey do not lend themselves to coloured indicators. For this reason, three-phase control panels will often use indicator lights of the old colours.
Modern systems installed by electricians
Increasingly, the jobs performed within the framework of electrical services must mount installation, which is responsible for supervising the specified object. It turns out that electricians not only assume the camera, but very often they take to install intercoms or video intercoms, which largely can increase the safety of people living in the building. This is very important in facilities where daily scrolls many people, such as in high-blocks and so on. These modern systems make people feel much safer in their own home.